JSW Plastics Machinery Inc. Home Molding Machine Training Program Market Place Contact Us About Us Site Map




Our on-sale products offer reliability, dependability, and superb customer service in a whole bundle with the lowest price possible!
Contact Us
master@jswpmi.com

Large Size Electric Servo Drive Injection Molding Machine
Standard Equipment

Model J-ELIII
Equipment Controller
SYSCOM 2000
Injection and Plasticizing Unit
Open nozzle (tip type) o
Barrel 1) o
M3 mixing screw 2) o
Screw suck back o
Purge cover (with LS) o
Swivel injection unit (with fower asst) o
Cold start-up prevention o
Mold-Pause changeover function o
Automatic purging circuit o
Sprue break timing selection o
Suck back timing select o
Injection and recovering program control (Closed-loop control) Injection speed 1-6 steps
Injection pressure 1-6 steps
Holding pressure 1-6 steps
Screw speed 1-3 steps
Screw back pressure 1-3 steps
Transfer to holding pressure by sensing injection speed (IVS Control) o
Automatic greasing o
Cylinder temperature control (SSR) 3) o
Nozzle temperature control (SSR) o
Cylinder temperature remote setting o
Soft pack servo control o
Hopper o
Mold Clamping Unit
Self-lubricating toggle bushings o
Automatic greasing o
High-performance mold platen support o
Remote setting of mold open-close speed o
Remote setting of moving platen position o
Remote setting of ejector speed o
Remote setting of ejector point o
Automatic mold height adjuster o
Remote setting of mold height o
Automatic mold clamping force setting o
Compression molding (1-6 steps) o
Mold protection device o
Safety devices (electric and mechanical) o
Take-out robot mounting holes o
Controller
TFT color LCD controller with SYSCOM touch panel Color LCD
Memory of molding conditions Int.
Data card o (one)
Soft touch start-up function o
Printer output terminal 4) o
Self-diagnostic function o
Overall set screen o
Molder's assist-information (Basic system) o
Dual function o
Time clock o
Non attend operation switch o
Robot interface o
Japanese/English Switching function 5) o
Monitor
Cylinder temperature monitoring function o
Heater circuit break o
Injection pressure monitor (IPM) o
Injection wave form monitor o
Injection wave form memory o
Statistical analysis function o
Table display o
Display of mold temperature 6) o
Link and busing greasing alarm o
Abnormal alarm buzzer o
Production monitoring 7) o
Cycle monitor display o
Action monitor o
Alarm set screen 8) o
Maintenance service 9) o
History of alarm o
Set value history o
Servo alarm o

Notes:

1) 1400H: N2000F Bi-metallic barrel, 2300H and higher: Nitrided.
  2) 2300H and higher (1400H: GP2)
  3) Up to 1400H (2300H and higher: MC)
  4) The printer, printer cable, and receptacle are optional.
  5) The Japanese/English switching function is standard equipment.
  6) Sensor and cable are not included.
  7) Setting of production quantity and advance notice are possible and completion time is displayed.
  8) Monitoring functions of the following particulars are equipped as standard. (Cycle time, injection time, recovery time, mold opening-closing time, cushion, injection start position, changeover position to holding pressure, injection pressure, changeover pressure to holding, screw back pressure.)
  9) Maintenance service time and areas are displayed.

 
(C) 2002 JSW Plastics Machinery Inc.